Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
*1
The guide for the right edge reference position is the after heater or the longest mark of the label on the eject
guide.
*2
When media holding plates are attached, within 5mm of the left and right edges of the media is recognized as the
media edge.
For example, if the Side Margin is set to 5mm, the actual margin is 10mm. Note that if the media holding plates
are attached incorrectly, this value fluctuates.
"Loading Media (SC-F7100 Series)" on page 28
U
"Loading Media (SC-F7000 Series)" on page 33
U
*3
The value when jobs are printed continuously. Differs by the length the media was pulled when the media is
loaded.
*4
The value selected for Side Margin(Left) in the setup menu. The default value is 5 mm.
*5
The total of the values selected for Print Start Position and Side Margin(Right) in the setup menu. The default
settings for Print Start Position and Side Margin(Right) are 0 mm and 5 mm.
*6
Leave left and right margins of 10 mm or more when using media holding plates. Narrower margins could result
in printing over the plates.
Note:
❏ When side margins are configured on both the printer and RIP, this becomes the combined value.
❏ If the total of the print data width and side margin exceeds the printable area, a portion of the data will not be printed.
❏ If the following points are not observed when Media Size Check is Off, printing may occur outside the left and right
edges of the media. Ink used outside the edges of the media will stain the inside of the printer.
❏
Ensure that the print data width does not exceed the loaded media width.
❏
When media is loaded to the left of the right side reference position, align the Print Start Position setting with the
position where the media set.
"Printer Setup Menu" on page 96
U
User's Guide
Basic Operations
67
Advertisement
Table of Contents
