Epson SC-F7100 series User Manual page 132

SC-F7100 Series/SC-F7000 Series
J
At the front side of the printer, keep the
adjustment paper taut, place a ruler on the front
side of the white line on the platen, and then draw
a line with a pen or other writing instrument.
K
Pull out the adjustment paper from the rear side,
move it to a position 5 cm from the left edge of the
roll core, and then insert it into the printer.
User's Guide
Appendix
L
M
132
At the front side of the printer, keep the
adjustment paper taut and check the positions of
the white line on the platen and the line drawn in
Step 10.
If the drawn line and white line are misaligned as
shown in the illustration below, proceed to Step
13. If they are aligned, proceed to Step 14.
While checking the state of the two lines on the
front side of the printer, use the hexagon wrench
to adjust the screw on the rear side of the printer
so that the drawn line aligns with the position of
the dotted line.
If the drawn line is below the white line, rotate the
adjustment screw counterclockwise. If the drawn
line is above the white line, rotate the adjustment
screw clockwise. One turn of the screw moves the
line about 1 mm.
The adjustment is complete when the drawn line
reaches the position of the dotted line.