Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Removing Media
You can now remove the media from the roll holders. To
remove the media, reverse the steps you followed to load
it.
Using the Auto Take-up
Reel Unit
The usage method depends on your printer. Choose the
method suited to your printer.
When using the SC-F7100 Series
See the following section.
When using the SC-F7000 Series
"Media Loading (SC-F7000 Series)" on page 50
U
Media Loading (SC-F7100 Series)
The Auto Take-up Reel Unit automatically takes up
media as it is printed, improving the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side in
Taking-up with printed side in places the printed
surface on the inside of the roll. Printed side in is
recommended in most situations.
Taking-up with printed side out places the printed
surface on the outside of the roll.
User's Guide
Basic Operations
Printed side out
42
!
Caution:
❏ Be sure that your hands or hair do not get
caught in the Auto Take-up Reel Unit while it
is in operation.
Failure to observe this precaution could result
in injury.
❏ Perform the following procedure to correctly
secure the roll core for the Auto Take-up Reel
Unit into place.
Injury may occur if the take-up roll falls.
Points to remember for correct
take-up
Observe the following points for correct take-up of
media.
❏ We recommend using a take-up roll core with the
same width as the media. If a take-up roll core of a
different width is used, the take-up roll core may
bend, and the media will be taken up incorrectly.
❏ We recommend Printed side in for the take-up of
media. When take-up cannot be perfomed
correctly with Printed side out, take-up using
Printed side in.
❏ Media less than 36 inches may be taken up
incorrectly.
Advertisement
Table of Contents
