SC-F7100 Series/SC-F7000 Series
Auto Take-up Reel Unit
The parallel adjustment method for the Auto Take-up
Reel Unit depends on your printer. Choose the method
suited to your printer.
"When using the SC-F7100 Series" on page 134
U
"When using the SC-F7000 Series" on page 140
U
When using the SC-F7100 Series
A
Use the large hexagon wrench to loosen the four
fixing screws on the front of the printer as shown
in the illustration.
B
Loosen the roll core holder locking screws and
adjust the roll core holders so that the distance
between the two is wider than the roll core.
User's Guide
Appendix
C
134
c
Important:
If the left roll core handle shaft is not visible,
rotate the handle as shown in the
illustration below until it stops.
Tighten the roll core holder locking screw to
align the right roll core holder with the position
of dotted line.