Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
c
Important:
As shown in the identified sections in the
illustration below, if the tensions of the left
and right edges of the media are different,
the media that follows cannot be taken up
correctly. If there is slack on one side, flip the
Manual switch to
peel the tape, and then restart from Step 1.
E
Confirm that the edges of media taken up on the
roll core are not misaligned.
c
Important:
If the edges of media taken up on the roll core
are misaligned, the media that follows
cannot be taken up correctly. When
misaligned, rewind the media, peel the tape,
and then restart from Step 1.
User's Guide
Basic Operations
F
to rewind the media,
Removing the Take-up Roll
(SC-F7100 Series)
This section describes how to remove media from the
take-up reel.
48
Set the Auto switch to
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
❏ Perform the following procedure to properly
remove the take-up roll.
Injury may occur if the take-up roll falls.
.
Advertisement
Table of Contents
