Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
K
Select the numbers for all colors and press Z.
Note:
To rewind the media, press the u button. Stop
rewinding before the media is past the cutter
groove (on the pressure roller side).
If the leading edge of the media is curled, stop
rewinding before the media reaches the inner side
of the front cover.
L
If the final color has been configured, the printer
returns to a ready state.
Feed Adjustment
Feed Adjustment is used to correct banding (horizontal
banding, lines, or strips of uneven color).
Two methods are available for Feed Adjustment:
❏ Visually inspect print results and enter a correction
by hand.
❏ Enter a correction during printing and inspect the
results.
Notes on correct adjustment
The condition of media is important for correct Feed
Adjustment.
Observe the following points when loading media.
❏ Feed Adjustment varies with the media used. Load
the media for which feed adjustment is required
under the same conditions as the actual print job.
For example, if you are using the Auto Take-up Reel
Unit for printing, the Auto Take-up Reel Unit
should also be used for feed adjustment.
❏ We recommend performing adjustment again in
the following cases, even if the media has been
adjusted.
❏ When the media type is the same but the
width is different.
❏ When the following settings have been
changed: Feeding Tension
*1
Tension
, Media Tension
User's Guide
Basic Operations
❏ Pull the media to the prescribed position before
Using a Test Pattern
Buttons that are used in the following settings
A
B
C
*1
, Take-up
*2
64
❏ When Media Suction has been changed.
*1: SC-F7100 Series only; *2: SC-F7000 Series only
performing Feed Adjustment. Correct adjustment
may not be possible if the media is not pulled
sufficiently because the condition of the leading
edge of the media may worsen due to waves or other
issues.
Loading MediaU
"Loading and Exchanging
Media" on page 27
Confirm that the media has been pulled to the
prescribed position.
Correct adjustment may not be possible if the
media is not pulled sufficiently.
Loading MediaU
"Loading and Exchanging
Media" on page 27
After confirming that the printer is ready, press
the Menu button.
The settings menu will be displayed.
Select Media Setup and press the Z button.
Advertisement
Table of Contents
