Epson SC-F7100 series User Manual page 43

SC-F7100 Series/SC-F7000 Series
Attaching the roll core
A
Set the Auto switch to Off.
B
After confirming that the media is loaded
correctly, press the d button to feed the media as
far as the Auto Take-up Reel Unit roll core
holder.
c
Important:
Always press the d button to feed the media
as far as the roll core holder. If the media is
pulled by hand, the media may twist during
take-up.
User's Guide
Basic Operations
C
D
43
Loosen the roll core holder locking screws and
adjust the roll core holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the left roll core handle shaft is not visible,
rotate the handle as shown in the
illustration below until it stops. The roll core
can not be properly loaded if the handle
shaft is not visible.
Align the right roll core holder with the right
edge of the media and tighten the locking screw.