Epson SC-F7100 series User Manual page 63

SC-F7100 Series/SC-F7000 Series
❏ Pull the media to the prescribed position before
performing Head Alignment. Correct adjustment
may not be possible if the media is not pulled
sufficiently because the condition of the leading
edge of the media may worsen due to waves or other
issues.
Loading MediaU "Loading and Exchanging
Media" on page 27
Buttons that are used in the following settings
A
Confirm that the media has been pulled to the
prescribed position.
Correct adjustment may not be possible if the
media is not pulled sufficiently.
Loading MediaU
Media" on page 27
B
After confirming that the printer is ready, press
the Menu button.
The settings menu will be displayed.
C
Select Media Setup and press the Z button.
D
Use the d/u buttons to select Customize
Settings and press the Z button.
E
Use the d/u buttons to select a media setting
bank number between 1 and 30 and then press
the Z button.
Note that any settings already saved in the printer
will be overwritten.
F
Use the d/u buttons to select Head Alignment
and press the Z button.
G
Use the d/u buttons to select Manual(Uni-D) or
Manual(Bi-D) and press the Z button.
User's Guide
Basic Operations
"Loading and Exchanging
H
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary.
"Cutting Media" on page 40
U
Note:
To rewind the media, press u. Stop rewinding
before the media is past the cutter groove (on the
pressure roller side).
If the leading edge of the media is curled, stop
rewinding before the media reaches the inner side
of the front cover.
I
Check the pattern and select the pattern number
that has the least gaps.
In the following example, this would be pattern
number 2.
C1
1
J
When C1 is displayed on the control panel, select
the number recorded in Step 9.
SC-F7100 Series
Use the l/r buttons to select the number and
press the Z button.
SC-F7000 Series
Use the d/u buttons to select the number and
press the Z button.
63
2 3