SC-F7100 Series/SC-F7000 Series
I
While checking the state of the two lines on the
front side of the printer, use the hexagon wrench
to adjust the screw so that the drawn line aligns
with the position of the dotted line.
If the drawn line is below the white line, rotate the
adjustment screw clockwise. If the drawn line is
above the white line, rotate the adjustment screw
counterclockwise. One turn of the screw moves
the line about 1 mm.
J
Use the hexagon wrench to tighten and firmly
secure the 4 screws.
User's Guide
Appendix
K
L
143
Pull out the adjustment paper from the printer,
loosen the left roll core holder locking screw, and
remove the roll core holder.
Remove the roll core.