Epson SC-F7100 series User Manual page 34

SC-F7100 Series/SC-F7000 Series
c
Important:
If the right holder handle shaft is not visible,
rotate the handle as shown in the
illustration below until it stops. The media
cannot be properly loaded if the handle shaft
is not visible.
D
Place media on the roll support oriented
according to how it is rolled (see below) and
position it as indicated by the mark on the label.
Printable Side Out
Printable Side In
If the label does not have the loading position,
mark it on the label as instructed in the Setup
Guide.
U Setup Guide
User's Guide
Basic Operations
E
F
34
Note:
Be sure the option selected for Roll Type in the
Customize Settings menu matches how the
media is rolled. Roll Type defaults to Printable
Side Out. Be sure to select Printable Side In after
loading media rolled printable side in.
For more information see U
page 60
Raise the lift lever on the left side of the printer to
lift the media into position, then firmly insert the
roll holder.
If the roll of media has an outer diameter which is
less than 140 mm, lift it up by your hands, and set
it to the roll holder. The roll core will not reach
the holder when raised using the lift lever.
Tighten the roll holder fixing screw until the
screw no longer turns to fix the roll holder in
place.
"Roll Type" on