Epson SC-F7100 series User Manual page 137

SC-F7100 Series/SC-F7000 Series
I
While checking the state of the two lines on the
front side of the printer, use the hexagon wrench
(large) to adjust the screw so that the drawn line
aligns with the position of the dotted line.
If the drawn line is below the white line, rotate the
adjustment screw clockwise. If the drawn line is
above the white line, rotate the adjustment screw
counterclockwise. One turn of the screw moves
the line about 1 mm.
J
Use the hexagon wrench (large) to tighten and
firmly secure the 4 screws.
User's Guide
Appendix
K
L
137
Pull out the adjustment paper from the printer.
Bring the adjustment paper to a position 5 cm
from the left edge of the roll core. Pass the lead
edge of the adjustment paper by the front of the
media guide bar and then insert it into the
printer.