Turn Signal Light Removal/Installation - Honda 2003 NPS50 Ruckus Service Manual

2. Turn Signal Switch Inspection
I nspect the turn signal switch for continuity
(page 1 9-22).
- •
Does continuity exist?·
NO
-
YES
REMOVAL/INSTALLATION
FRONT
Remove the inner cover (page 3-5).
Disconnect the turn signal light connectors.
Remove the clamp.
Remove the nut and turn signal light.
Route the wires Install the turn signal light to the headlight bracket
and tighten the nut to the specified torque.
properly.
TORQUE: 9.8 N·m (1.0 kgf·m, 7 lbf . ft)
Clamp the wire Installation is in the reverse order of removal.
with a new clamp.
REAR
Release the wires from the clamp.
Disconnect the turn signal light connectors.
Remove the nut and turn signal light.
I nstall the turn signal light to the tail light bracket
and tighten the nut to the specified torque.
TORQUE: 9.8 N·m (1.0 kgf·m, 7 lbf. ft)
Route the wfres Installation is in the reverse order of removal.
properly.
•
Faulty turn signal switch.
An open circuit in the Black and/or
•
Gray wire of the turn signal relay.
An open circuit in the G reen/black
wire between the turn signal light
and ECM.
Faulty ECM.
LIGHTS/METERS/SWITCHES
�
s
CLAMP
1 9-7