Battery Removal/Installation; Voltage Inspection - Honda 2003 NPS50 Ruckus Service Manual

BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL/INSTALLATION
Turn the ignition switch to OFF.
Remove the inner cover (page 3-5).
Remove the fuse box cover by releasing its hook.
Disconnect the battery negative (-) cable by remov­
ing the terminal bolt.
Disconnect the fuse box/battery positive (+) cable by
removing the terminal bolt.
Remove the bolt and battery holder.
Remove the battery.
•
Install the removed parts in the reverse order of
removal.
•
NOTE:
Connect the fuse box/positive (+) cable first, then
connect the negative (-) cable.
After connecting the battery cables, coat the ter­
minals with dielectric grease.

VOLTAGE INSPECTION

Remove the fuse box cover (page 1 6-6).
Measure the battery voltage using a commercially
available digital multimeter.
VOLTAGE (20"C/68"F):
•
Fully charged:
Under charged: Below 12.3 V
NOTE:
When measuring the battery voltage after charg­
ing, leave it for at least 30 minutes, o r the accu­
rate results cannot be obtained because the
battery voltage fluctuates just after charging.
1 6-6
13.0 - 13.2 V
FUSE BOX/POSITIVE (+) CABLE
BATIERY
BATIERY HOLDER
TERMINAL BOLT
BOLT