Remove the wire band from the water pump stay.
Remove the grommet from the crankcase groove.
Remove the two bolts, clamp a n d ignition pulse
generator.
Remove the three bolts and stator.
Remove the woodruff key from the crankshaft.
INSTALLATION
Clean any oil from the tapered portion of the crank
shaft and flywheel.
Install the woodruff key in the crankshaft key
groove.
Install the stator a n d tighten the bolts to the speci
fied torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the grommet to the crankcase groove prop
erly.
Install the ignition- pulse generator and wire clamp
properly as shown.
Tighten the bolts securely.
Route the alternator/sfarter wires under the guide of
the stator base.
Install the wire band to the water pump stay.
Route and clamp the alternator/starter wire properly
(page 1-1 5).
Connect the alternator/starter 3P and 6P connectors.
ALTERNATOR/STARTER
1 2-5