Drive Shaft Inspection - Honda 2003 NPS50 Ruckus Service Manual

If the bearing is left on the drive shaft, remove it
using the special tool.
TOOL:
Universal bearing puller
INSPECTION
Remove the oil seal.
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly a n d quietly.
Also check that the bearing outer race fits tightly in
the case.
Remove and discard the bearing if the races do not
turn smoothly and quietly, or if they fit loosely in the
case.
Check the countershaft and final gear shaft sliding
surfaces for wear or damage.
Check the drive shaft, final gear shaft, countershaft
and counter gear for wear or damage.
Coat each gear teeth with oil.
07931-4630000 or
equivalent
commercially
available in U.S.A.
DRIVE SHAFT BEARING
COUNTERSHAFT SHAFT SLIDING SURFACE
COUNTER G EAR
DRIVE SHAFT
FINAL REDUCTION
BEARING PULLER
FINAL GEAR SHAFT
COUNTERSHAFT
1 1 -7