Clutch/Driven Pulley Removal; Clutch/Driven Pulley Disassembly - Honda 2003 NPS50 Ruckus Service Manual

KICKSTARTER/DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
CLUTCH/DRIVEN PULLEY
REMOVAL
Remove the drive pulley (page 10-9).
Hold the clutch outer with the special tool a n d
loosen the clutch outer nut.
TOOL:
Universal holder
Remove the nut a n d clutch outer.
Remove the clutch/driven pulley assembly.
Remove the drive belt from the driven pulley.
DISASSEMBLY
Set the clutch spring compressor onto the clutch/
driven pulley, aligning the bosses with the holes i n
the clutch.
Hold the clutch spring compressor in a vise.
TOOL:
Clutch spring compressor
Compress the clutch/driven pulley and remove the
To prevent loss of
stopper ring.
tension, do not
compress the
clutch spring more
than necessary to
Do not remove the special tool when the stop­
remove the stopper
per ring is removed. If so, some parts may pop
ring.
out causing an i nju ry.
1 0- 1 2
07725-0030000
07LME-GZ40200 or
07960-KM1000A
(U.S.A. only)