Brake/Tail Light Removal/Installation - Honda 2003 NPS50 Ruckus Service Manual

3. Bral<e Light Circuit Inspection
Remove the front cover (page 3-6).
With the ignition switch turned to ON, check that
the battery voltage is present between the Black
wire connector of the brake light switch and
body ground.
The brake light switch circuit is normal if battery
voltage is present.
Is battery voltage present?
NO
-
- •
YES
REMOVAL/INSTALLATION
Release the wires from the clamp.
Disconnect the brake/tail light connectors.
Remove the bolt and tail light cover.
Route the wire Remove the bolts/washers and brake/tail light.
harness correctly
Installation is in the reverse order of removal.
(page 1-15).
•
•
•
•
•
Open circuit i n the Black wire.
Faulty main relay (page 1 6-1 1 )
Blown sub fuse ( 1 0A).
Faulty ignition switch (page 1 9-20)
Faulty ECM.
Open circuit in the Green/yellow wire
between the brake light switch and
brake light.
LIGHTS/METERS/SWITCHES
TAIL LIGHT COVER
BRAI<EfTAIL LIGHT