MAINTENANCE
Raise the rear wheel off the ground and support the
scooter securely.
Check for worn engine mounting bushings by grab
bing the rear wheel and attempting to move the
wheel side-to-side.
Replace the bushings if any looseness is noted
(page 8-4).
N UTS, BOLTS, FASTEN ERS
Check that all chassis nuts, bolts and screws are
tightened to their correct torque values (page 1-10).
Check that all cotter pins, safety clips, hose clamps
and cable stays are in place and properly secured.
WHEELS/TIRES
Check the tire pressure with a tire pressure gauge
when the tires are cold.
RECOMMENDED TIRE PRESSURE:
FRONT: 175 I<Pa (1.75 kgf/cm2, 25 psi)
REAR:
Check the tires for cuts, embedded nails, or other
damage.
Check the front wheel and rear wheel for trueness
(refer to page 1 4-7 and page 1 5-4).
Measure the tread depth at the center of the tires.
Replace the tires when the tread depth reaches the
following limits.
MINIMUM TREAD DEPTH:
FRONT: 0.8 mm (0.03 in)
REAR:
4- 1 8
175 kPa (1.75 l<gf/cm2, 25 psi)
0.8 mm (0.03 in)