Turn Signal Light; Bulb Replacement - Honda Metropolitan CHF50 Service Manual

LIGHTS/METERS/SWITCHES
2. Headlight Circuit Inspection (2)
With the headlight connector plugged in, ground
the Green/orange wire terminal with a jumper
wire.
The headlight circuit is normal if the headlight is
turned on when the ignition switch is turned ON
while the engine is running.
Is the headlight turned on?
NO - Open circuit in the Blue wire between
the 9P connector of the left handlebar
switch and headlight.
YES - Check that the Green/orange wire is not
open. If it is not an open circuit, replace
the ECM with a new one.
REMOVAL/INSTALLATION
Remove the front cover (page 2-4).
Remove the bolts, screws and headlight unit.
Install the headlight unit in the reverse order of
removal.
Adjust the headlight beam vertically and horizon-
tally (page 3-18).
TURN SIGNAL LIGHT
BULB REPLACEMENT
Remove the screw and turn signal light lens.
While pushing the bulb in, turn it counterclockwise
to remove it, and replace it with a new one.
Make sure the rubber seal is installed in position
and is in good condition, and replace it with a new
one if necessary.
Install the lens by aligning the hook with the tab of
the turn signal light, and tighten the screw.
TAB
HOOK LENS
SCREW
BULB
INSPECTION
NOTE:
• The turn signal lights can be operated with the
ignition switch turned to ON even though the
engine is not started. The lights will not work if
the battery voltage falls below the prescribed
limit. However, they will be ready for operation
after starting the engine.
18-5