Cylinder Head Cover Installation - Honda 2003 NPS50 Ruckus Service Manual

CYLINDER HEAD/VALVES
Remove the special tool to cancel the lock of the
After 05 model:
tensioner l ifter.
'
Coat new 0-rings with oil.
Install new 0-rings to the PCV joint and cam chain
tensioner l ifter groove.
Install the PCV joint to the cam chain tensioner.
After '05 model: Install the bolt and washer.
Tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 lcgf·m, 7 lbf . ft)
Make sure the index line on the cam sprocket aligns
with the index mark on the stopper plate when the
"T" mark on the flywheel is aligned with the index
mark on the crankcase.
Install the following:
- Water pump (page 7-10)
- Belt case cover (page 10-6)
CYLI NDER H EAD COVER INSTALLATION
Clean the gasket g roove of the cylinder head cover.
Coat the new 0-rings with oil and install them into
the grooves of the cylinder head cover.
Install the cylinder head cover to the cylinder head.
Install the bolts and tighten them in a crisscross pat­
tern in two or three steps.
Connect the engine breather and air supply hoses.
Install the fuel tank (page 6-28).
9-22
� .,
0-RINGS
... .. .
,