Under Cover Removal/Installation; Rear Fender Removal/Installation - Honda 2003 NPS50 Ruckus Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
UNDER COVER
REMOVAL/INSTALLATION
Remove the following:
- Floor step (page 3-7).
- Fuel tank (page 6-28).
Be careful not to Open the fuel pump lid by releasing its hooks.
Disconnect the fuel pump 2P connector.
damage the hooks.
Release the main wire harness and throttle cable
from the guide of the under cover.
Be careful not to Remove the brake cable clamp bolt/washer while
damage the brake holding the clamp.
cable. Remove the under cover.
1-15).
Route the wire har- Install the removed parts in the reverse order of
ness, cables and removal.
hoses properly
(page
REAR FENDER
REMOVAL/INSTALLATION
Release the carburetor vacuum hose from the ,--- -- -- -- -- -- -- -- -- -,
clamp.
Remove the bolt, bolts/washers and rear fender.
Installation is in the reverse order of removal.
3 -8
2P CONNECTOR
BRAKE CABLE
CARBURETOR VACUUM HOSE
BOLT
BOLTS/WASHERS
BOLT/WASHER
TH ROTTLE CABLE
.