FUEL SYSTEM
Loosen the connecting hose band screw and insula
tor band screw.
Be careful not to Remove the carburetor as an assembly.
damage the
insulator and
connecting hose.
Disconnect the water hose.
Loosen the insulator band screw and remove the
insulator from the intake manifold.
Remove the bolts, intake manifold and D-ring.
Seal the cylinder head intake port with a shop towel
or cover it with a piece of tape to prevent any for
eign material from dropping into the engine.
CARBURETOR DISASSEMBLY
NOTE:
• Do not remove the throttle position sensor
unless it is necessary to replace it or disassemble
the carburetor. If the sensor is removed, be sure
to reset the data (page 17-10).
Remove the screw and throttle position sensor.
6-8
THROTTLE POSITION SENSOR