Headlight Removal/Installation; Turn Signal Light Bulb Replacement; Turn Signal Light Inspection - Honda 2003 NPS50 Ruckus Service Manual

LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Remove the headlight bulb (page 1 9-4).
Remove the bolts and headlight.
Install the removed parts in the reverse order of
removal.
Adjust the headlight aim (page 4-17).
TURN SIGNAL LIGHT
BULB REPLACEMENT
Remove the screw and turn signal light lens.
While pushing the bulb in, turn it cou nterclockwise
to remove it, and replace it with a new one.
Make sure the rubber seal is installed in position
and is in good condition, and replace it with a new
one if necessary.
Install the lens by aligning its hook with the slot of
the turn signal light, and tighten the screw.
•
INSPECTION
NOTE:
The turn signal lights can be operated with the
ignition switch turned to O N even though the
engine is not started. The lights will not work if
•
the battery voltage falls below the prescribed
limit. However, they will be ready for operation
after starting the engine.
Check the sub fuse ( 1 0A) before performing this
inspection.
All the turn signal lights do not operate.
1 . Turn Signal Relay Inspection
Remove the inner cover (page
Disconnect the turn signal relay 3P connector.
Using the jumper wire, short the Black and Gray
wire terminals.
Turn the ignition switch to ON, and operate the
turn signal switch.
Do turn signals tight up?
NO
YES
1 9-6
3-5).
.
•
•
GO TO STEP 2.
-
Faulty turn signal relay.
-
Poorly connected terminal.
HEADLIGHT
HOOK SLOT
SCREW LENS
BULB
RUBBER SEAL