Checking Your Own Number - Panasonic Foma p705im Instruction Manual

Set Caller ID Notification to Network
You can set whether to notify your caller ID on the network.
1 m1Service1Caller ID notification
1Do the following operations.
Item
1ON or OFF
Activate
Check setting You can check the setting contents of "Activate".
Set Caller ID Notification when Making a Call
Each time you dial out, you can set whether to notify your caller ID.
1
Enter a phone number
or
bring up the detailed display of a Phonebook entry,
redial item, dialed call record, or received call record.
i(
2
)1Notify caller ID
1Don't notify or Notify caller (OFF or ON)
≥ To release "Notify caller ID", select "Cancel prefix". Whether to notify or not
follows the setting for "Activate" of "Caller ID notification".
Set "Notify/Not Notify" by Entering "186/184"
You can select whether to notify the other party of your phone number
also by entering "186"/"184" before the other party's phone number.
To notify your caller ID
1
186 Destination phone number1d or
≥ Press l(
) to make a videophone call.
m + 1 - 7 -
Operation/Explanation
o ( O
Not to notify your caller ID
1
184 Destination phone number1d or
≥ Press l(
) to make a videophone call.
Information
≥ When you make a call and hear the guidance requesting your caller ID (see
page 382), follow the steps of "To notify your caller ID" to enter "186" and redial.
≥ You cannot set "Caller ID notification" while "
< >
Own Number

Checking Your Own Number

≥ Your phone number (own number) is stored on the UIM.
1 m1Phonebook1Own number
o to switch the tabs. N
You can press
≥ See page 355 for storing/displaying personal data.
Information
≥ In Dual Mode of 2in1, you can switch between Number A and Number B by
+ O o (
pressing ) from the Own Number display. "
A, and " " appears for Number B.
≥ When you replace a UIM with another one (2in1 contractor
while using 2in1, perform "2in1 function OFF" (see page 388) and then set "2in1
setting" to "YES", or perform "Auto acquire No. B" (see page 356), to acquire the
correct Number B.
) When you replace a UIM with another one (2in1 contractor
perform "2in1 function OFF" as well to update the owner's information to the
correct one.
O o (
" is displayed.
m +
List tab
Phone number tab
Own Number display
" appears for Number
2in1 contractor)
2in1 non-contractor),
)
0 -
47