Panasonic Foma p705im Instruction Manual page 461

Reserve Date and Time for Updating Software (Reserve Update)
When downloading takes time or the server is busy, you can set in
advance the date and time for starting the software update by
communicating with the server.
1
Select "Reserve" from the Software Update display.
The date and time which can be reserved are displayed.
≥ The server's time table appears for the software update reservation.
When you select "Others"
After communicating with the server, you can select the date and time you
want. The availability of each time zone is displayed on the time selection
display as follows:
: Available, : Almost full,
When you select one time zone you want, you can communicate with the
server again to display candidates for reserving time.
2
Confirm the date and time you selected. Select "YES".
Your FOMA phone communicates with the server
again and then the reservation is completed.
: Not available
When the reserved time comes
The display on the right appears and about five seconds
later the software update starts automatically.
Before the reserved time, fully charge the battery pack,
place the FOMA phone with the Stand-by display shown in a
place within reach of radio wave.
Information
≥ Note that updating may not start even when the reserved time arrives if you are
using another function.
≥ The software update may not be started if an alarm is activated.
≥ If you execute "Initialize" on page 364 after completing the reservation, the
software update does not start even when the reserved time arrives. Make a
reservation for the software update again.
Check, Change, or Cancel the Reserved Date and Time
Select "Software update" from the setting menu, then enter your
Terminal Security Code and select "Update"; then you can confirm the
reserved time.
You can change or cancel the reserved date and time from
the display for checking reservation. To change, select
"Change". To cancel, select "Cancel".
End Software Update
If you select "NO" or "Cancel" from each display, the display for
ending the operation appears.
Select "YES"; then the software update ends and the Stand-by display returns. To
return to the previous display, select "NO".
Information
≥ If the battery level points "
" during operation, the software rewriting is not done
and the operation ends.
459