Panasonic Foma p705im Instruction Manual page 529

Specify Communication Port
1
" (Menu)" of "FOMA PC setup
software"1Select "
setup)".
[Auto-setup (recommended)]
The connected FOMA phone is automatically specified. Usually,
select "Auto-setup".
COM (Specifying COM port)
When specifying a COM port number, specify the COM port
number (COM1 through 99) the FOMA phone is connected to.
≥See page 42 for how to check the COM port number.
2
Click "OK".
The settings are applied.
Select Packet Communication from
" (Easy Setting)"
Using "mopera U" or "mopera" as an access point
This section explains how to make settings for a
high-speed packet communication of 3.6 Mbps maximum.
This setting is for when you use DoCoMo Internet
connection service "mopera U" or "mopera" as a provider.
High-speed packet communication:
You are charged according to the amount of data sent/
received. You can execute data communication without
worrying about time.
High-speed packet communication of up to 3.6 Mbps for
receiving and up to 384 kbps for sending is available.
Note that a communication fee becomes expensive if
you send/receive a large amount of data such as by
browsing web pages having many images, or by
downloading the data.
≥The communication speed for both sending and receiving is up to
384 kbps for "mopera" connection.
1
Click "
2
Select "
communication)", then click "
Confirm that "
then click " (Next)".
(Communication
(Easy Setting)".
(Packet
(Next)".
(Packet communication)" is checked,
3
Select " mopera U
mopera U)" or " mopera
to mopera)", then click "
To use "mopera U", select " mopera U
U)". To use "mopera", select " mopera
When " mopera U
confirmation display appears asking whether you have signed up for it. If
you have signed up, click "
≥See page 37 for using a provider other than "mopera U" or "mopera".
4
Click "OK".
≥The system obtains the access point name (APN) setting from the
FOMA phone connected to the personal computer. Wait for a while.
5
Enter an access point name, then click "
(Next)".
You can specify any name for the currently created connection.
Enter a plain name in the "
≥You cannot enter the following half-pitch characters:
¥, /, :, ¢, ?, !, <, >, |, and ".
≥For the setting of "
"
≥"mopera U" supports connection types of both "
connection)" and "
select " (IP connection)".
6
Click " (Next)".
If the access point is "mopera U" or "mopera", you can connect even
if the " (user name)" and "
blank.
7
Confirm the set information, then click "
(Complete)".
The set contents are listed on the display. Confirm that there is no
problem on the set contents, then click "
≥To change the set contents, click "
≥If "
(Create a dial-up shortcut on the desktop)" is checked, a dial-up
shortcut will be created on the desktop.
8
Click "OK".
The setting is completed.
Open the dial-up shortcut icon automatically created
on the desktop; then the connection display for
starting communications appears. After confirming that the
connection starts, you can start the Internet browser or mail browser
for communication. (See page 40)
36
(Connect to
(Connect
(Next)".
(Connect to mopera
(Connect to mopera)".
(Connect to mopera U)" is selected, the
(YES)".
(Access point name)" field.
(caller ID notification)", select
[Not set (recommended)]" for overseas use.
(IP connection)". For overseas use,
(password)" fields are
(Complete)".
(Back)".
(PPP