Setting Dial-Up Network - Panasonic Foma p705im Instruction Manual

Setting Dial-up Network

Set Packet Communication
The operation below explains how to set a connection
for packet communication without using the "FOMA PC
setup software".
The packet communication uses AT commands to carry
out the settings from a personal computer. To specify
settings, communication software to enter AT command
is required. "Hyper Terminal", which is attached to
Windows as the standard software, is used here for
explanation.
When using DoCoMo Internet access service "mopera
U" or "mopera", you do not need to set an access point
name (APN) (see page 21).
You can set "caller ID notified/not notified" (see
page 23) as required. (You need to set "caller ID
notified" when using "mopera U" or "mopera".)
<Packet communication setting flow using AT commands>
Confirm the COM port number (See page 20)
Start the communication software that enables the entry of AT commands
(See step 3 of "Set an Access Point Name (APN)" on page 21)
Set an access point name (APN) (See step 7 on page 22)
Set "caller ID notified/not notified"
(See step 2 of "Set Caller ID Notified/Not Notified" on page 23)
Set others (See page 47)
Exit the communication software (See step 9 on page 22)
AT commands
≥The AT commands are used to control a modem. The FOMA phone,
which conforms to the AT commands, supports some extended
commands and unique AT commands.
≥By entering AT commands, you can carry out detailed setting for packet
communication and FOMA phone, and confirm (display) the setting
contents.
≥If the entered AT command is not displayed, enter "ATE1
Confirm COM Port Number
To manually carry out the communication setting, you
need to specify a COM port number, which is assigned
to "FOMA P705i "/"PROSOLID
after you install the "FOMA communication setup files"
(driver).
The confirmation method varies depending on the
operating system of your personal computer.
≥When using DoCoMo Internet access service "mopera U" or
"mopera", you do not need to set an access point name (APN);
therefore, you do not need to confirm the modem.
For Windows XP
1
"
(Control panel)".
2
From "
(Printer and the other hardware)" in "
options)".
3
If the "
display appears, enter "
(City code/Area code)", then click "OK".
4
Open the "
COM port number in the "
point)" field of "FOMA P705i " or
"PROSOLID
≥The COM port number you confirmed is used to set an access
point name (APN) (see page 21).
≥The contents on the property display and COM port number vary
depending on the personal computer you use.
".
20
" (modem) embedded
(Start)" 1Open "
(Control panel)", open "
(Phone and modem
(Address information)"
(Modem)" tab, confirm the
(Access
", then click "OK".