Panasonic Foma p705im Instruction Manual page 54

Display during dialing
The other party's name and icon are displayed if the party's phone number and
name are stored in the Phonebook. However, the image is not displayed even if it is
stored in the Phonebook.
≥ If the same phone number is stored with multiple names in the Phonebook, the
name that comes first in the search order (see page 86) is displayed.
≥ The phone number instead of the name is displayed if the Phonebook entry is
stored as secret data or if Personal Data Lock is activated.
If you entered a wrong phone number
Each time you press r, the digit on the far right is cleared. If you press and hold
r for at least one second, all the digits are cleared and the Stand-by display
returns.
o to move the cursor to the digit you want to clear, and then press r to N
≥ Press
clear it. To clear all the digits on and to the right of the cursor, press and hold r
for at least one second.
If a videophone call could not be connected
The reason why it could not be connected is displayed. (The displayed reason might
not be the same as the actual reason depending on the type of the other party's
phone and contract for network services.)
52
Messages
Check number, then You have dialed a non-existent phone number.
redial
Busy The other party is busy. (Depending on the receiver's
phone, this message might be displayed during packet
communication as well.)
Busy with packet The packet communication is progress at the other end.
transmission
Out of service area/ The other party's phone is out of the service area or
power off turned off.
Set caller ID to ON Your caller ID is not notified.
(when dialing "visualnet", etc.)
Your call is being During forwarding
forwarded
Redial using voice call The other party activates Call Forwarding Service but the
forwarding destination phone does not support
videophone calls.
Upper limit has been The upper limit for the plan with the limit function (Type
exceeded Limit, Family Wide Limit) is exceeded.
Connection failed
Please make your call You did not make a videophone call from the IP
from the i-mode web (Information Provider) site among i-mode official sites (at
page dialing to V-live).
Connection failed Redial after setting "Activate" of "Caller ID notification" to
"ON".
This may appear in the case other than above.
Auto-redialing
If "Voice call auto redial" is set to "ON", and a videophone call is not connected, a
voice call is automatically made.
≥ Videophone calls cannot be connected to the phones that do not support the
videophone function, or to the phones that are out of the service area or turned off
even if they are videophones. If you have set "Voice call auto redial" to "ON" and
attempt to dial a phone that does not have the videophone function, the number
will be redialed as a voice call. However, this operation might not work if you call an
ISDN-synchronous 64K or PIAFS access point or an ISDN videophone that does
not support 3G-324M (as of December 2007), or if you dial the wrong number.
Note that you could be charged for the communication.
≥ Once the videophone call has started communications, redialing as a voice call will
not be made.
Reasons