Setup - Yamaha CL5 Reference Manual

6.
Use the buttons in the CONTROL CHANGE MODE field to select the Control
Change transmission/reception mode.
You can choose one of the following two modes for Control Change transmission/reception.
• NRPN mode (when the NRPN button is on):
Various mix parameters on the CL series console will be transmitted and received on a single
MIDI channel as NRPN messages. If you select this mode, the assignments on the list will be
ignored.
• TABLE mode (when the TABLE button is on):
Various mix parameters on the CL series console will be transmitted and received on a single
MIDI channel as Control Change messages.
NOTE
The channel on which Control Changes are transmitted and received is specified by the PORT/
CH field on the MIDI SETUP page (see
7.
Use the buttons in the CONTROL CHANGE field to turn transmission and reception
on or off, and make settings for echo output.
Each button has the following function.
• Tx button....................Switches Control Change transmission on or off.
• Rx button....................Switches Control Change reception on or off.
• ECHO button ............Selects whether incoming Control Changes will be echoed out from the
MIDI transmit port.
8.
To change the event assignment for each control number, press the corresponding
event.
The MIDI CONTROL CHANGE popup window will appear. In this window you can specify the
event assigned to each control number. The window contains the following items.
1
page 145).
2
1
MODE field
Enables you to select the type of event.
2
PARAMETER 1/2 field
In conjunction with the MODE field, this field specifies the type of event.
NOTE
• The list shown is the same for all models of the CL series.
For the CL3/CL1, the display will indicate "Cannot Assign!" if you specify a parameter that does
not exist on that model.
• If NRPN mode is selected as the Control Change transmission/reception mode, the settings in
this window are ignored.
• For details on the events that can be assigned to Control Changes, refer to the Appendices
(see page 232).
9. In the order of the MODE field ➔ PARAMETER1 field ➔ PARAMETER2 field, specify
the type of event you want to assign.
Use the / buttons to select an item. Press the OK button to confirm the change and close the
MIDI CONTROL CHANGE popup window.
NOTE
• You can also press the desired event in the field to select it.
• If you press an item in the field to highlight it, you will be able to rotate one of the multifunction
knobs to select an event.
10.
Assign events to other control numbers in the same way.
When you operate the parameters you assigned on the CL series console, Control Change
messages will be transmitted to external devices. Similarly, if the corresponding Control Change
messages are sent from an external device on the appropriate channel, the parameters assigned to
those control numbers will change.
NOTE
• You can use the CLEAR ALL button to erase all assignments to control numbers. The INITIALIZE
ALL button will return all control number assignments to their default state.
• Assignments to control numbers are maintained as settings for the entire system, rather than for
individual scenes.
151
MIDI
Reference Manual