Yamaha CL5 Reference Manual page 38

5.
Use the MODE button to select either ST/MONO mode or LCR mode for each
channel.
6.
In the MASTER section on the top panel, make sure that the [ON] key for the
STEREO channel/MONO channel is turned on, and then raise the fader to an
appropriate level.
7.
In the INPUT section on the top panel, make sure that the [ON] key is turned on
for the input channel you want to control, and then raise the fader to an
appropriate position.
The subsequent steps will differ depending on whether ST/MONO mode or LCR mode was selected
for the channel in step 5.
■ Channels for which ST/MONO mode is selected
8.
In the TO STEREO/MONO popup window, use the STEREO/MONO button to turn
the signal sent from the input channel to the STEREO bus/MONO bus on or off.
For a channel that is set to ST/MONO mode, signals sent to the STEREO bus and to the MONO
bus can be switched on or off individually.
9.
In the TO STEREO/MONO popup window, use the TO ST PAN knob to set the
panning of a signal sent from the input channel to the STEREO bus.
■ Channels for which LCR mode is selected
8.
In the TO STEREO/MONO popup window, use the LCR button to turn signals sent
from the input channel to the STEREO bus/MONO bus on or off collectively.
For a channel that is set to LCR mode, signals sent to the STEREO bus and to the MONO bus are
switched on or off collectively.
9.
In the TO STEREO/MONO popup window, use the CSR knob to adjust the level
difference between signals sent from that channel to the STEREO (L/R) bus and to
the MONO (C) bus.
10.
In the TO STEREO/MONO popup window, use the TO ST PAN knob to set the
panning of signals sent from the input channel to the STEREO bus and MONO (C)
bus.
If the CSR knob is set to 0%, operating the TO ST PAN knob of an INPUT channel will change
the level of signals sent to the STEREO (L/R) bus and MONO (C) bus, as shown in the following
diagram. In this case, the TO ST PAN knob operates as a conventional PAN knob, and no signal
is sent to the MONO (C) bus.
L C
TO ST PAN knob
Operating the TO ST BALANCE knob of a STEREO channel will change the level of signals sent
from the STEREO L/R channels to the STEREO (L/R) bus and MONO (C) bus, as shown in the
following diagram. In this case, the TO ST PAN knob operates as a conventional BALANCE knob,
and no signal is sent to the MONO (C) bus.
L C
TO ST BALANCE knob
L C
TO ST BALANCE knob
38
Signal sent to the STEREO (L) bus
Signal sent to the STEREO (R) bus
R
Signal sent from the STEREO (L) channel to
the STEREO (L) bus
R
Signal sent from the STEREO (R) channel to
the STEREO (R) bus
R
Input channels
Reference Manual