Yamaha CL5 Reference Manual page 52

Using the Centralogic section
This method lets you use the multifunction knobs (in the Centralogic section) to simultaneously adjust
the send levels from the eight channels selected in the Centralogic section to the desired MATRIX bus.
1.
Make sure that an output port is assigned to the MATRIX bus to which you want
to send signals, and that your external device is connected to the corresponding
output port.
2.
Use the Bank Select keys in the Centralogic section to access the OVERVIEW screen
that includes the channels (MIX channels or STEREO/MONO channels) that you
want to control.
In the OVERVIEW screen, you can use the TO MATRIX field to adjust the send levels to the
MATRIX bus.
3.
Press the TO MATRIX SEND LEVEL knob for the desired send-destination MATRIX
bus.
A bold frame will appear around all TO MATRIX SEND LEVEL knobs for that MATRIX bus.
4.
Use multifunction knobs 1–8 to adjust the send level of the signals sent from up to
eight MIX channels or the STEREO/MONO channels to the selected MATRIX bus.
If necessary, you can use the Bank Select keys and the [SEL] keys in the Centralogic section to
switch the send-source channel.
NOTE
• If you want to monitor signals being sent to a specific MATRIX bus, use the Bank Select keys to
access the corresponding MATRIX channel in the Centralogic section, and then press the [CUE]
key for that MATRIX channel.
• If you again press the currently-selected MATRIX bus select button, cue monitoring will be turned
on for the related MATRIX channel. This method is convenient if you want to monitor a signal that
is being sent to the selected MATRIX bus.
5.
If you want to make detailed settings for MATRIX sends, press the TO MATRIX
SEND LEVEL knob inside the bold frame once again.
When you press the currently-selected TO MATRIX SEND LEVEL knob a second time, the
MATRIX SEND popup window will appear. The window includes the following items.
5
6
7
8
9
0
1
ALL PRE button
Sets the send point to "PRE. " (The send point is the point at which signals are sent from all send-
source channels — including the input and output channels — to the selected send destination.)
2
ALL POST button
Sets the send point to "POST. " (The send point is the point at which signals are sent from all send-
source channels — including the input and output channels — to the selected send destination.)
3
SEND FROM button
Press this button to switch to the "SEND from 8ch" popup window.
4
Send destination indicator
Indicates the currently-selected send destination.
52
4 1 2 3
Output channels
Reference Manual