Specifying The Channel Name And Icon - Yamaha CL5 Reference Manual

• LCR (Left/Center/Right)
Sends the input channel signal to the STEREO bus/MONO bus as a three-channel signal that
consists of the L/R channel plus the center channel.
• MIX ON/OFF (MIX send on/off)
This is an on/off switch for signals sent from the input channel to MIX buses 1–24.
• MATRIX LEVEL 1–24 (MATRIX send levels 1–24)
Adjusts the send level of signals sent from the input channel to VARI type MIX buses 1–24. As the
position from which the signal is sent to the MIX bus, you can choose from the following:
immediately before EQ, pre-fader, or post-fader.
• MATRIX ON/OFF (MATRIX send on/off)
This is an on/off switch for signals sent from the input channel to MATRIX buses 1–8.
• MATRIX LEVEL 1–8 (MATRIX send levels 1–8)
Adjusts the send level of the signal sent from the input channel to MATRIX buses 1–8. As the
position from which the signal is sent to the MATRIX bus, you can choose from the following:
immediately before the EQ, pre-fader, or post-fader.
• INSERT (MONO channels only)
You can patch the desired output/input ports to insert an external device such as an effect
processor. For the position of the insert-out/insert-in point, you can choose immediately before
the EQ, immediately before the fader, or immediately after the [ON] key.
• DIRECT OUT (MONO channels only)
You can patch this to any output port to send out the input signal directly from the corresponding
output port. For the position of the direct output, you can choose immediately before the HPF,
immediately before the EQ, immediately before the fader, or immediately after the [ON] key.
• METER
Meters the input channel level. You can switch the position at which the level is detected
(see page 109).

Specifying the channel name and icon

On the CL series unit, you can specify the on-screen name and icon for each input channel. This section
explains how to specify the channel name and icon.
1.
Access the OVERVIEW screen that includes the input channel for which you want
to specify the channel name and icon.
Channel number/Channel name field
2.
Access the PATCH/NAME popup window by pressing the channel number/channel
name field of the channel to which you want to assign the channel name and icon.
28
Input channels
Reference Manual