Yamaha CL5 Reference Manual page 42

6
Channel select button
Selects the send-source channel that you wish to control. The current channel icon, number, and
color appear on the button, and the channel name appears immediately below the button.
7
PRE/POST button
Switches the send point of each send-source channel between PRE and POST. If the button is on,
the send point is set to PRE.
8
SEND ON/OFF button
Switches the send of each send-source channel on or off.
9
SEND PAN/BALANCE knob
Sets the panning or balance of signals sent to the stereo send destination. If the send destination
is set to monaural or FIXED, this knob will not appear.
If the send source is monaural, this knob functions as a PAN knob.
If the send source is stereo, you can use the PAN/BALANCE mode
setting in the TO STEREO/MONO popup window to select whether
PAN/BALANCE will function as a PAN or BALANCE knob.
The knob for the mode selected here will appear.
0
SEND LEVEL knob
Indicates the level of signals sent to the selected send destination. Press this knob to control the
level using the multifunction knobs.
If the send destination is set to FIXED, only a gray circle will appear.
6.
Use the TO MIX/MATRIX SEND ON/OFF buttons to switch signals sent from the
input channels to the currently-selected MIX/MATRIX bus on or off.
7.
If necessary, use the PRE buttons to select the send point of a signal that is sent
from each input channel to a VARI type MIX/MATRIX bus.
NOTE
• If the PRE button is on, you can also select PRE EQ (immediately before the EQ) or PRE FADER
(immediately before the fader) for each MIX/MATRIX bus. This setting is made in the BUS SETUP
popup window (see page 192).
• The PRE button is not displayed for FIXED type MIX buses.
42
Input channels
Reference Manual