External Ha Port Select - Yamaha CL5 Reference Manual

Dgital mixing console yamaha cl5; cl3; cl1
Hide thumbs Also See for CL5:
Table of Contents

Advertisement

6
COMM PORT switch buttons
Specifies whether the external HA connected to the slot will be controlled remotely. Select
"SLOT1" if you want to remotely control the external HA.
4.
To specify the input ports for an external HA, press the EXTERNAL HA PORT SELECT
popup button for that rack.
The EXTERNAL HA PORT SELECT popup window will appear. The popup window includes the
following items.
1
1
PORT SELECT buttons
Specify the input ports to which the external HA is connected.
5.
Use the PORT SELECT buttons to specify the input ports to which the audio output
of the external HA is connected.
When you have finished making settings, press the CLOSE button to close the popup window.
NOTE
If an external HA is connected to one of the slots on the CL series console, you must specify an
appropriate input port manually. If this is set incorrectly, the external HA will not be detected
correctly when you patch input ports to input channels.
6.
To remotely control an external HA, press the rack in which the external HA you
want to control is mounted.
The EXTERNAL HA popup window will appear. Here you can remotely control the external HA
by using the on-screen knobs and buttons on the CL series console or the knobs on the top panel.
2
3
4
5
1
+48V MASTER
If an external HA is connected, the on/off status of the master phantom power is shown here.
(Switching this on or off is performed on the external HA itself.)
2
+48V button
Switches phantom power on or off for each channel.
3
GAIN knob
Indicates the gain level of the external HA. To adjust the value, press the knob to select it, and use
multifunction knobs 1–8. The level meter located immediately to the right of the knob shows the
input level of the corresponding port.
4
FREQUENCY knob/HPF button
These controllers switch on or off the high-pass filter built into the external HA, and adjust its
cutoff frequency. If you press the FREQUENCY knob to select it, you will be able to adjust it using
the corresponding multifunction knob.
5
Rack select tabs
Enable you to select the rack displayed in the EXTERNAL HA popup window.
NOTE
• If you connect an additional AD8HR, the setting for this AD8HR will be used. These knobs and
buttons are displayed in the EXTERNAL HA popup window even if an AD8HR is not connected,
allowing you to create and store a scene even while the AD8HR is not connected.
• Error messages related to the SB168-ES will not be displayed. In addition, you will be unable to
set the EtherSound parameters. Use the AVS-ESMonitor software application for these
functions.
142
I/O rack and external head amp
1
Reference Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cl3Cl1

Table of Contents