Using The Centralogic Section - Yamaha CL5 Reference Manual

Using the Centralogic section

You can use the multifunction knobs in the Centralogic section to adjust the send level of signals sent
from eight consecutive input channels to a specific MIX/MATRIX bus.
1.
Make sure that an output port is assigned to each MIX/MATRIX bus to which you
want to send signals, and that your monitor system, external effect, or other device
is connected to the corresponding output port.
2.
Use the Bank Select keys in the Centralogic section to access the OVERVIEW screen
that includes the input channel that you want to control.
In the OVERVIEW screen, you can use the TO MIX/TO MATRIX field to adjust the send levels
to the MIX/MATRIX bus.
3.
Press the TO MIX/MATRIX SEND LEVEL knob for the desired send-destination MIX/
MATRIX bus.
A bold frame will appear around all TO MIX/MATRIX SEND LEVEL knobs for that MIX/
MATRIX bus.
4.
Use multifunction knobs 1–8 to adjust the send level of signals sent from the (up
to) eight input channels to the selected MIX/MATRIX bus.
If necessary, you can use the Bank Select keys to switch the input channels that you want to assign
to the Centralogic section, and adjust the send levels from other input channels to the selected
MIX/MATRIX bus.
NOTE
If you want to monitor a signal being sent to a specific MIX/MATRIX bus, use the Bank Select
keys to assign the corresponding MIX channel to the Centralogic section, and then press the
[CUE] key for that MIX/MATRIX channel.
5.
If you want to make detailed settings for MIX/MATRIX sends, press the TO MIX/
MATRIX SEND LEVEL knob inside the bold frame once again.
When you press the currently-selected TO MIX/MATRIX SEND LEVEL knob a second time, the
MIX SEND popup window or the MATRIX SEND popup window will appear. This window
includes the following items.
4 1 2
5
6
7
8
9
0
1
ALL PRE button
Sets the send point to "PRE. " (The send point is the point at which signals are sent from all send-
source channels — including the input and output channels — to the selected send destination.)
At this time, the PRE/POST button will light.
2
ALL POST button
Sets the send point to "POST. " (The send point is the point at which signals are sent from all send-
source channels — including the input and output channels — to the selected send destination.)
At this time, the PRE/POST button will turn off.
3
SEND FROM button
Press this button to switch to the "SEND from 8ch" popup window.
4
Send destination indicator
Indicates the currently-selected send destination.
5
Send destination select buttons
Select MIX/MATRIX buses as the send destination.
41
3 4 1 2
5
6
7
8
9
0
Input channels
3
Reference Manual