Ch49-72/St In - Yamaha CL5 Reference Manual

7
7
PAN/BALANCE MODE button
Switches the knob function of the TO ST PAN/TO ST BALANCE knob on the STEREO channel.
If the ST/MONO/LCR mode select button is set to LCR mode, the following button and knob are
4
displayed instead of the ST/MONO button
8
9
8
LCR button
This button is an overall on/off button for signals sent from a channel to the STEREO bus and
MONO bus. If this button is off, no signal will be sent from the corresponding input channel to
the STEREO bus or MONO bus.
9
CSR knob
Adjusts the relative level of signals sent from the channel to the STEREO (L/R) bus and to the
MONO (C) bus, in the range of 0–100%. To adjust the value, press the knob to select it, and then
operate the corresponding multifunction knob. (see
.
page 38)
TO STEREO/MONO popup window
(CH1-48, CH49-72/ST IN(CL5), CH49-64/ST IN(CL3), ST IN(CL1))
Adjusts the status of a signal sent from the corresponding input channel to the STEREO/MONO bus.
You can also adjust the pan or balance setting in groups of eight selected channels.
1
2
3
4
1
Channel select button
Selects the channel. You can select multiple channels simultaneously.
2 Σ clipping indicator
Lights to indicate a signal is clipping at some point in the channel.
3
TO ST PAN/TO ST BALANCE knob
Adjusts the panning or balance.
To adjust the value, press the knob to select it, and then operate the corresponding multifunction
knob.
If the signal reaches the overload point at any meter detection point in that channel, the indicator
to the right of the knob will light.
4
ST/MONO indicators
If a channel is set to ST/MONO mode, these indicators will individually indicate the on/off status
of signals sent from the channel to the STEREO bus/MONO bus.
If a channel is set to LCR mode, the LCR indicator will be displayed in this location. The LCR
indicator indicates the on/off status of all signals sent from that channel to the STEREO bus/
MONO bus.
4.
Access the eight-channel TO STEREO/MONO popup window.
37
Input channels
Reference Manual