Assignable Encoders - Yamaha CL5 Reference Manual

Assignable encoders

You can assign the desired function to the GAIN/PAN/ASSIGN knob on the fader strip of each channel,
and control the function using the knob.
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
Press the USER SETUP button to access the USER SETUP popup window.
3.
Press the USER DEFINED KNOBS tab to select the USER DEFINED KNOBS page.
If you are logged-in as the Administrator, you can also select the USER DEFINED KNOBS and
ASSIGNABLE ENCODER for GUEST page to make assignable knob settings for the Guest
account.
4.
Press the button in the ASSIGNABLE ENCODER field.
The ASSIGNABLE ENCODER SETUP popup window will appear.
5.
Use the / buttons in the lower part of the field or the multifunction knobs on
the top panel to select the function you want to assign.
For details on the assignable functions and their parameters, refer to
assigned to the assignable encoders" on
NOTE
SELECTED SEND is the default setting. It functions as the send to the MIX/MATRIX channel that
is selected for SENDS ON FADER in the Function Access Area.
6.
Press the OK button to close the ASSIGNABLE ENCODER SETUP window.
7.
Press the [GAIN/PAN/ASSIGN] key on the top panel repeatedly
to select ASSIGN.
The CL3 and CL1 feature one [GAIN/PAN/ASSIGN] key. Therefore, the
function of all GAIN/PAN/ASSIGN knobs will change simultaneously.
On the CL5, you can switch the knob function in block A (left side) and
block C/Master fader section (right side) independently by using the
corresponding [GAIN/PAN/ASSIGN] keys.
NOTE
This assignment does not apply to the multifunction knobs in the Centralogic section, since these
knobs are used to control on-screen parameters.
8.
Operate the GAIN/PAN/ASSIGN knob on each fader strip.
167
User settings (Security)
"Functions that can be
page 247.
Reference Manual