Yamaha RX10LTGTYL Service Manual page 1375

A.C. MAGNETO AND STARTER CLUTCH
INSTALLATION
1. Install:
S Starter clutch
NOTE:
S While holding the magneto rotor with the
sheave holder, tighten the starter clutch bolt.
S Do not allow the sheave holder to touch the
projection on the magneto rotor.
Sheave holder
90890-01701, YS-01880-A
2. Tighten:
S Bolts 1
Bolt (starter clutch):
12 Nm (1.2 mSkg, 8.7 ftSlb)
LOCTITE
3. Install:
S Woodruff key
S Magneto rotor
S Washer
S Bolt
NOTE:
S Clean the tapered portion of the crankshaft
and the magneto rotor hub.
S When installing the magneto rotor, make sure
the woodruff key is properly seated in the key-
way of the crankshaft.
4. Tighten:
S Bolt 1
Bolt (A.C. magneto rotor):
130 Nm (13.0 mSkg, 94.0 ftSlb)
NOTE:
S While holding the A.C. magneto rotor 2 with
the sheave holder 3 , tighten the magneto ro-
tor bolt.
S Do not allow the sheave holder to touch the
projection on the magneto rotor.
Sheave holder
90890-01701, YS-01880
5-35
ENG
R