Cap/Wipe/Purge Assembly - Xerox ii LINXSolid Inkjet 100 Service Manual

Cap/Wipe/Purge Assembly

WARNING
6-42 ii LINX™ Solid Inkjet 100 Printer Service Manual
Even when the printer is turned off, AC line voltages may be
present at the printer heaters while the printer is plugged into AC
power.
1. Remove the right cover.
2. Remove the left cover.
3. Disconnect the head-tilt spring. Tilt back the printhead and
center it.
4. Remove the top cover.
5. Remove the ink loader.
6. Disconnect the wiring harness leading from the cap/wipe/purge
assembly to the power supply wiring harness. Clip the tie
wraps and disconnect the vacuum hose leading to the vacuum/
pump module.
7. Rotate the cap wipe drive gear to position the cap/wipe/purge
assembly 25 mm (1 in.) from the top of its travel.
8. Place a few sheets of paper between the drum and the cap/
wipe/purge assembly to prevent scratching the drum.
9. Remove the right timing belt's lower pulley to create slack in
the right timing belt.
10. Remove the metal vacuum line from the assembly.
11. Remove the wiring from the right cap/wipe/purge assembly
bracket.
12. Push the wiring through the print engine's frame so that you
can unloop it from the cap/wipe/purge assembly.
13. While holding onto the cap/wipe/purge assembly, remove the
three pin screws that hold the cap/wipe/purge assembly in the
grooves on each side of the print engine.
Reverse these steps to reinstall the cap/wipe/purge assembly. Refer to
the wiring diagrams in Appendix C for details on dressing the cap/
wipe/purge wiring.