Xerox ii LINXSolid Inkjet 100 Service Manual page 163

Install the Gap Tools
The left and right gap tools must be installed properly to correctly
adjust the printhead-to-drum spacing. To install the tools (refer to
Figure 4-7):
1. Postition the tip of the gap tool between the printhead and the
drum.
2. Hook one side of the tool through the hole in the chassis.
3. Hook the other side of the tool over the chrome shaft above the
printhead.
NOTE: The left and right gap tools should never be interchanged
because they are different thicknesses.
To properly adjust the printhead-to-drum gap, use only one gap tool at
a time.
To prevent the printhead adjustment from changing, remove the gap
tool when torquing the printhead screws.
Adjustments 4-19