Xerox ii LINXSolid Inkjet 100 Service Manual page 233

Removing Cap/Wipe/Purge Belts
Vacuum
inlet
Short pin
screw
Figure 6-27. Removing the Cap/Wipe/Purge Assembly
1. Remove the right, left and top covers.
2. Disconnect the head-tilt spring. Tilt back the printhead.
3. Remove the ink loader.
4. Manually rotate the cap/wipe/purge drive enough to raise the
cap/wipe/purge assembly so the two belt locks are accessible on
left and right side of the printer frame.
Cap Wipe/ Purge
assembly
Long pin
screw
Short pin
screw
Removal and Replacement 6-43
840-4-43