Xerox ii LINXSolid Inkjet 100 Service Manual page 222

6-32 ii LINX™ Solid Inkjet 100 Printer Service Manual
Install
removal
tool
Removal tool leg
(in up position)
Figure 6-21. Removing the Printhead
Installation. If not already in place, install the printhead's data
ribbon cable to the printhead.
1. Install the printhead with the tile mount about half-way back.
Work the head up/down on each side to be certain the head is
all the way down and seated. Then tighten the two mounting
screws so they are snug.
2. Loosen the printhead's four (Head-to-Drum HTD) gap
adjustment screws and push the printhead away from the
drum; then tilt the printhead to its print position by turning
the process gear on the left side of the printer and attach the
head tilt spring. The head tilt arm will be seated at the end of
the slot of the steel band.
Slide lock
to secure
to printhead
Loosen
mounting
screws
840-4-24