Xerox ii LINXSolid Inkjet 100 Service Manual page 85

4,000: PC Processor Control Supervisor (continued)
Front Panel Software Error Code
Display
PC-DEV_FAULT_300DPI_CAL
4,006.45
pc fault: 300 dpi calib
(0x2406)
PC_DEV_FAULT_600DPI_CAL
4,007.46
pc fault: 600 dpi calib
(0x2407)
PC_DEV_FAULT_STUCK_DMC
4,008.47
pc fault: DM oil sense
(0x2408)
PC_DEV_FAULT_DM_CAM_BEGIN
4,009.48
pc fault: DM cam start position
(0x2409)
PC_DEV_FAULT_DM_CAM_BU_WU
4,010.40
pc fault: DM cam blade up/web down
(0x240a)
PC_DEV_FAULT_DM_CAM_BU_WD
4,011.41
pc fault: DM cam blade up/web down
(0x240b)
PC_DEV_FAULT_DM_CAM_END
4,012.42
pc fault: DM cam end position
(0x240c)
PC_DEV_FAULT_GEAR_GRIND
4,013.43
pc fault: PM disengage
(0x240d)
PC_DEV_FAULT_6x6DPI_CAL
4,014.44
pc fault: 6x6 dpi calib
(0x240e)
Error Codes
Meaning
Calibration Failure: Target Volt-Sec Area of 300
DPI could not be achieved. Check the hardware.
The head may need to be renormalized.
Calibration Failure: Target Volt-Sec Area of 600
DPI could not be achieved. Check the hardware.
The head may need to be renormalized.
Failure to advance the drum maintenance oiling
mechanism. It has been in the new state for too
long. Check the hardware.
At the start of a drum maintenance cycle, when
the DM cam position should have been at blade
down/web down, the DM cam home sensor
should have been TRUE and was instead FALSE.
Check DM cam solenoid, clutch, home sensor,
and related hardware.
During the drum maintenance cycle, when the
DM cam position should have been at blade
up/web up, the DM cam home sensor should
have been FALSE and was instead TRUE. Check
DM cam solenoid, clutch, home sensor, and
related hardware.
During the drum maintenance cycle, when the
DM cam position should have been at blade
up/web down, the DM cam home sensor should
have been FALSE and was instead TRUE. Check
DM cam solenoid, clutch, home sensor, and
related hardware
At the end of a drum maintenance cycle, when
the DM cam position should have been at blade
down/web down, the DM cam home sensor
should have been TRUE and was instead FALSE.
Check DM cam solenoid, clutch, home sensor,
and related hardware.
During power-on initialization, the engine is
unable to disengage the process motor. Prior to
declaring this fault, the engine has attempted to
move the process motor through enough
revolutions to disengage the head tilt
mechanism, but the motor stalled somewhere
along the way. The X-axis was then displaced to
the right 0.15 inches and the disengage was
repeated, but the motor stalled again. This leads
to this device fault. The head is unable to move
on the tilt axis, perhaps because it is colliding
with something (head restraint pin, cap, poorly
installed ink loader, screwdriver, etc.).
Calibration Failure: 600x600 DPI waveform could
not be generated. Check the hardware. The
head may need to be renormalized
Error Codes and Messages 2-7