Xerox ii LINXSolid Inkjet 100 Service Manual page 169

6. On the side of the printer corresponding to the wrinkling,
tighten the set screw clockwise 1/8 of a revolution, using a 4
mm hex driver. On the side that does not wrinkle, loosen its set
screw 1/8 of a revolution.
NOTE: Whatever adjustment is added to one side must be taken away
from the other side to maintain roller balance.)
7. Reassemble the printer and again print the Service Test Print
16: Primary Solid Fills.
8. If wrinkling still occurs on the same side, repeat Step 6 and 7.
Do not adjust the set screws more than 3/8 of a revolution from
their original position. Any adjustment beyond this point results in
ink adhesion problems.
CAUTION
9. If wrinkling continues to occur, replace the drum/transfix
assembly.
3/8 turn
maximum
Figure 4-10. Adjusting The Transfix Roller Pressure Springs
Original
registration mark
3/8 turn
maximum
Tension spring
set screws
0388-38
Adjustments 4-25