Xerox ii LINXSolid Inkjet 100 Service Manual page 218

6-28 ii LINX™ Solid Inkjet 100 Printer Service Manual
Drum home
flag
Drum position
encoder wheel
Figure 6-18. Marking the Drum Home Flag Sensor Alignment
6. Rotate the tilt gear to orient the gear's missing teeth to the
drum position sensor assembly's rear mounting screw.
7. With a small, flatblade screwdriver, slide the retaining spring
out of the encoder wheel's groove toward the encoder disk.
8. Remove the three screws securing the drum position sensor
assembly housing to the print engine. Insert the gap tool to
hold the encoder wheel in position. Slide the assembly off the
drum shaft. If necessary, use the small flat-blade screwdriver
to push the encoder disk hub along the shaft as you remove the
assembly.
Mark on the drum shaft to
align with the home flag
840-4-17