Xerox ii LINXSolid Inkjet 100 Service Manual page 221

Disconnect
Figure 6-20. Plugging the Reservoir Holes
8. Rotate the removal tool's plastic leg into its up position. Slide
the removal tool's standoff locks inward.
9. Place a few sheets of paper between the printhead and the
drum to protect the drum surface.
10. Carefully, lower the printhead removal tool onto the printhead.
Rotate the process motor to tilt the printhead forward about
2.5 cm (1 inch).
11. Slide the standoff locks outward to secure the tool to the
printhead. Loosen the two mounting screws securing the
printhead in place.
12. Lift and remove the printhead. Lower the removal tool leg to
safely restthe printhead on a flat surface.
13. Using the printhead removal tool, reverse the removal steps to
reinstall the printhead.
14. Perform the Cold Printhead-to-Drum Spacing Adjustment and
then the Hot Printhead-to-Drum Spacing Adjustment.
Silicone
reservoir
plugs
840-4-23
Removal and Replacement 6-31