Xerox ii LINXSolid Inkjet 100 Service Manual page 258

®
Mac OS: Ethertalk Configuration
7-10 ii LINX™ Solid Inkjet 100 Printer Service Manual
NOTE: The printer's AppleTalk connection works with Macintosh
System software 7.0, 7.1, 7.5, 7.6, 8.0, 8.1, and 8.5.
Finding the Printer's Name in the Chooser
1. From the Apple menu, select Chooser.
2. In the left-hand side of the Chooser, find the LaserWriter 8
icon. (If the LaserWriter 8 icon is not in the Chooser, you need
to install the printer driver.) Click on the LaserWriter 8 icon.
NOTE: To install a Solid Inkjet 100 Printer driver on a Macintosh
network (via Ethertalk), refer to "Installing Printer Software" in
Chapter 2 under "Macintosh Software".
3. If a list of zones appears in the lower-left portion of the
Chooser, select the proper zone.
4. A list of printers appears in the right portion of the Chooser;
find your printer's name. The printer's default name is listed on
the Configuration Page (see "Printing a Configuration Page"
earlier in this chapter). If the name does not appear, check the
cable connection between your printer and the network.
NOTE: It is possible for the Printer Name field on the Configuration
Page to be blank. When the printer is powered up, it uses a default
name and then checks to see that no other printer on the network has
the same name. If enough printers with the same default name are
present, it can take several minutes for the printer to establish a
unique name. If the Printer Name field on the Configuration Page is
blank, wait a short time and reprint the Configuration Page.