Xerox ii LINXSolid Inkjet 100 Service Manual page 240

Removing Preheater Exit Sensor
WARNING
CAUTION
6-50 ii LINX™ Solid Inkjet 100 Printer Service Manual
Allow the printer to cool for 30 minutes.
1. Remove the right, left and front covers.
2. Remove the upper feed roller assembly.
3. Remove the paper/drum heater.
4. Disconnect the preheater exit sensor wiring harness from the
J170 of the left I/O board.
Be careful in the next step not to scratch or mar the drum.
5. Remove the screw securing the preheater exit sensor to the
inside of the left drum/ transfix assembly frame. Remove the
sensor and its wiring harness.
Reverse these steps to install the preheater exit sensor.