Xerox ii LINXSolid Inkjet 100 Service Manual page 246

Installing the Optional Ethernet Network Card
6-56 ii LINX™ Solid Inkjet 100 Printer Service Manual
1. Power down the printer. Leave the power cord plugged in to
provide a ground path for static discharges. Remove the
interface cable.
2. Loosen the two securing screws holding the network card or
the cover plate and remove it.
3. Slide in the replacement network card and tighten the two
screws.
4. Reconnect the interface cables. Turn on the printer and print
the configuration page; it lists information regarding the
Ethernet interface.
5. For installations of a new Ethernet card, affix the Ethernet
address label to the underside of the top cover where it can
easily be accessed. Also apply a "Do not use" sticker over the
10baseT Ethernet port on the main board. The built-in
Ethernet port is disabled by the presence of an Ethernet
network card.
Network
card
Figure 6-37. Installing Network Card
840-4-41