Streaks Or Lines Down The Print - Xerox ii LINXSolid Inkjet 100 Service Manual

Printing And Print Quality Problems
5. Check the flexible, white paper deskew springs on the inside of
the front cover. Ensure none are bent, damaged, or missing.
6. The printer should be installed on a flat, level surface.
Generally, print problems fall into the following six categories:
• Streaks or lines in the prints
• No printing
• Printing too light or too dark
• Poor quality printing
• Image is offset or cut off
• Wrinkling
Streaks Or Lines Across The Print
1. Check the Y-axis belt tension. If the Y-axis drive is not smoothly
and consistently rotating the drum, horizontal bands or lines
appear in the print.
2. Replace the Y-axis motor.
3. Replace the power control board.

Streaks Or Lines Down The Print

1. Clean the blade of the drum maintenance drawer.
2. Possible missing or weak jet. Print the Service Test Print 2,
Weak/Missing Jets, to determine if a jet is not performing.
Perform up to three printhead cleaning cycles to try to clean a
clogged jet.
3. If necessary, turn off the printer and allow the printhead to cool
for 4 hours.
4. Test the vacuum system for proper vacuum levels and
operation.
5. Ensure that no wiring harnesses are interfering with the
horizontal slewing of the printhead. In such a case, the streaks
or lines should be parallel and evenly spaced.
6. Check for media in the exit path.
Troubleshooting 3-23